सिभिल इन्जिनियरिङ

सिभिल इन्जिनियरिङ: प्रश्न र उत्तर

सही लागेको विकल्पमा थिच्नुहोस्। सही भए हरियो, गलत भए रातो देखिन्छ; ३ सेकेन्डपछि सही उत्तर र व्याख्या देखिन्छ।

सही: ० / ०

2881. The permissible angular misclosure of a closed traverse is commonly expressed in the form K√N, where N is:

      कThe number of sides squared खThe perimeter of the traverse in km गThe number of angles (stations) measured घThe least count of the instrument
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2882. The error in a measured horizontal angle caused by inaccurate centring of the theodolite over the station is greatest when:

      कThe sights are very long खThe sights are short गThe instrument is perfectly levelled घThe angle is measured by repetition
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2883. In precise levelling, lines of sight are kept well above the ground surface (e.g. not below about 0.5 m on the staff) mainly to reduce errors due to:

      कRefraction, which is irregular close to the heated ground खEarth's curvature गGraduation errors of the staff घCollimation error
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2884. In an EDM instrument, the zero (additive) error and the scale error differ in that:

      कNeither affects measured distances खThe zero error grows with distance, whereas the scale error is constant गBoth are proportional to the square of the distance घThe zero error is constant for all distances, whereas the scale error is proportional to the distance measured
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2885. An assembly of overlapping aerial photographs fitted together to form a continuous picture of an area is called a:

      कOrthophoto खStereogram गMosaic घContour map
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2886. On a tilted aerial photograph, the point where the bisector of the angle of tilt meets the photograph is called the:

      कPrincipal point खIsocentre गNadir point घFiducial centre
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2887. If the smallest length that can be plotted accurately on paper is 0.25 mm, the smallest ground distance that can be shown on a map of scale 1:1000 is:

      क0.25 m ख2.5 m ग0.025 m घ25 m
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2888. A plan differs from a map in that a plan is:

      कUsed only for showing relief खDrawn to a very small scale, covering a large area गAlways drawn without any scale घDrawn to a relatively large scale, covering a small area
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2889. A perambulator (measuring wheel) is used for:

      कMeasuring vertical angles खPrecise measurement of base lines गRough measurement of distances, such as along roads, by counting wheel revolutions घLevelling across rivers
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।

2890. A pantograph is an instrument used to:

      कMeasure horizontal angles खEnlarge or reduce a map or plan to a different scale गMeasure the area of a figure घSet out right angles
      💬 टिप्पणी / गल्ती रिपोर्ट (०)

      छलफल / प्रश्न उत्तरमा गल्ती छ

      पठाउनुहोस्

      टिप्पणी जाँचपछि मात्र देखिन्छ।