सिभिल इन्जिनियरिङ
सिभिल इन्जिनियरिङ
Civil Engineering · ५,१७१ प्रश्न
५,१७१ प्रश्न उपलब्ध। मोड छान्नुहोस्:
सिभिल इन्जिनियरिङ: प्रश्न र उत्तर
सही लागेको विकल्पमा थिच्नुहोस्। सही भए हरियो, गलत भए रातो देखिन्छ; ३ सेकेन्डपछि सही उत्तर र व्याख्या देखिन्छ।
सही: ० / ०
-
Moorum, used in road shoulders and subgrades, is:
सही उत्तर: घ) A gravelly material formed by weathering and disintegration of rock
Moorum is a naturally occurring disintegrated rock material, usually red or brown, used for low-cost road works.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Stone masonry built with finely dressed stones of regular shape laid in fine mortar joints is called:
सही उत्तर: ग) Ashlar masonry
Ashlar masonry uses accurately dressed blocks with thin joints; rubble masonry uses roughly shaped stones.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Silica bricks and magnesite bricks are examples respectively of:
सही उत्तर: ख) Acid refractory and basic refractory bricks
Silica bricks resist acidic slags (acid refractory); magnesite bricks resist basic slags (basic refractory).
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
In the field hardness test of a good brick:
सही उत्तर: क) No impression should be left on the surface when it is scratched with a fingernail
A well-burnt brick is hard enough that a fingernail cannot scratch it.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
In a Vertical Shaft Brick Kiln (VSBK):
सही उत्तर: घ) Green bricks are loaded at the top and move down through a vertical shaft as fired bricks are removed below
The VSBK is an energy-efficient continuous updraught kiln where batches of bricks descend through the firing zone.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
The zig-zag brick kiln, widely promoted in Nepal to replace older fixed-chimney kilns, is an improvement of the Bull's trench kiln in which:
सही उत्तर: ग) Bricks are stacked so that hot gases follow a zig-zag path, improving combustion and reducing emissions
The zig-zag air path increases heat transfer and gives more complete combustion, so fuel use and smoke are reduced.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
In Flemish bond brickwork, each course consists of:
सही उत्तर: ख) Headers and stretchers laid alternately in the same course
Flemish bond places headers and stretchers alternately in every course, giving a more attractive face than English bond.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
English bond in brick masonry consists of:
सही उत्तर: क) Alternate courses of headers and stretchers
English bond has a full header course followed by a full stretcher course; it is considered the strongest common bond.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
A brick laid with its length perpendicular to the face of the wall, so that only its end is visible, is called a:
सही उत्तर: घ) Header
A header shows its end on the wall face; a stretcher shows its long side.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
In 'slop moulding' of bricks by hand, the mould is:
सही उत्तर: ग) Dipped in water before each brick is moulded so that the clay does not stick
In slop moulding the mould is wetted; in sand moulding it is dusted with sand, which gives sharper edges.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
यी अभ्यास प्रश्न हुन्, आधिकारिक प्रश्न होइनन्। पाठ्यक्रम, विज्ञापन र नतिजाका लागि सम्बन्धित निकायको आधिकारिक वेबसाइट हेर्नुहोस्। उत्तरमा गल्ती भेटे प्रश्नमुनिको "टिप्पणी / गल्ती रिपोर्ट" मा लेख्नुहोस्।
नमस्ते! पाठ्यक्रम, सामान्य ज्ञान, भाषा परीक्षा वा कुनै प्रश्नको उत्तर बुझ्न सोध्नुहोस्।
AI ले गल्ती गर्न सक्छ। महत्वपूर्ण कुरा आधिकारिक स्रोतमा जाँच्नुहोस्।