इन्जिनियरिङ सेवा सब-इन्जिनियर (पाँचौँ तह) – प्राविधिक पत्र
इन्जिनियरिङ सेवा – सब-इन्जिनियर (पाँचौँ तह)
Sub-Engineer – 5th Level · Engineering Service
१,९४० प्रश्न उपलब्ध। मोड छान्नुहोस्:
प्राविधिक पत्र: प्रश्न र उत्तर
सही लागेको विकल्पमा थिच्नुहोस्। सही भए हरियो, गलत भए रातो देखिन्छ; ५ सेकेन्डपछि सही उत्तर र व्याख्या देखिन्छ।
सही: ० / ०
-
Expansive black cotton soil shows large swelling mainly because it contains the clay mineral:
सही उत्तर: ग) Montmorillonite
Montmorillonite has weak interlayer bonds that absorb water and swell greatly.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
If the drainage path length of a clay layer is doubled, the time for the same degree of consolidation becomes:
सही उत्तर: घ) 4 times
t = TvH²/cv, so time varies with the square of drainage path.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
A normally consolidated clay layer 4 m thick has Cc = 0.3, e0 = 1.0, initial effective stress 100 kPa and stress increase 100 kPa. Its primary consolidation settlement is about:
सही उत्तर: घ) 181 mm
S = CcH/(1+e0) log((σ0+Δσ)/σ0) = 0.6 x log2 ≈ 0.181 m.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Using the empirical relation Cc = 0.009(LL - 10) for normally consolidated clay, the compression index of a clay with liquid limit 50% is:
सही उत्तर: क) 0.36
Cc = 0.009(LL - 10) = 0.009 x 40 = 0.36 (Terzaghi-Peck / Skempton relation).
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
A clay has preconsolidation pressure 200 kPa and present effective overburden 100 kPa. Its overconsolidation ratio is:
सही उत्तर: ख) 2
OCR = σ'p/σ'0 = 200/100 = 2.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Secondary consolidation of clay is mainly due to:
सही उत्तर: ग) Plastic readjustment (creep) of soil particles after pore pressure dissipation
Secondary compression occurs after primary consolidation, due to creep of the soil skeleton.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Under a rigid footing resting on cohesionless sand, the contact pressure is:
सही उत्तर: ग) Maximum at the centre and minimum at the edges
In sand, lack of confinement at the edges gives low edge pressure and maximum at the centre.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Vertical stress below a uniformly loaded area of irregular shape is conveniently found using:
सही उत्तर: घ) Newmark's influence chart
Newmark's chart is used to find stress under any shaped loaded area.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
A 2 m x 2 m footing carries 200 kN. By the 2:1 dispersion method, the average vertical stress at 2 m below the base is:
सही उत्तर: क) 12.5 kPa
σz = Q/((B+z)(L+z)) = 200/(4 x 4) = 12.5 kPa.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Using Boussinesq's equation, the vertical stress directly below a 100 kN point load at 2 m depth is about:
सही उत्तर: ख) 11.9 kPa
σz = 0.4775Q/z² = 0.4775 x 100/4 ≈ 11.9 kPa.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
यी अभ्यास प्रश्न हुन्, आधिकारिक प्रश्न होइनन्। पाठ्यक्रम, विज्ञापन र नतिजाका लागि सम्बन्धित निकायको आधिकारिक वेबसाइट हेर्नुहोस्। उत्तरमा गल्ती भेटे प्रश्नमुनिको "टिप्पणी / गल्ती रिपोर्ट" मा लेख्नुहोस्।
नमस्ते! पाठ्यक्रम, सामान्य ज्ञान, भाषा परीक्षा वा कुनै प्रश्नको उत्तर बुझ्न सोध्नुहोस्।
AI ले गल्ती गर्न सक्छ। महत्वपूर्ण कुरा आधिकारिक स्रोतमा जाँच्नुहोस्।