इन्जिनियरिङ सेवा सब-इन्जिनियर (पाँचौँ तह) – प्राविधिक पत्र
इन्जिनियरिङ सेवा – सब-इन्जिनियर (पाँचौँ तह)
Sub-Engineer – 5th Level · Engineering Service
१,५०३ प्रश्न उपलब्ध। मोड छान्नुहोस्:
प्राविधिक पत्र: प्रश्न र उत्तर
सही लागेको विकल्पमा थिच्नुहोस्। सही भए हरियो, गलत भए रातो देखिन्छ; ५ सेकेन्डपछि सही उत्तर र व्याख्या देखिन्छ।
सही: ० / ०
-
In astronomical surveying, the point on the celestial sphere vertically above the observer is called the:
सही उत्तर: क) Zenith
The zenith is directly overhead; the nadir is the point directly below the observer.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
In the northern hemisphere, the latitude of an observer can be found approximately by measuring the:
सही उत्तर: घ) Altitude of the pole star (Polaris)
Polaris lies very close to the celestial north pole, whose altitude equals the observer's latitude.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
In the Universal Transverse Mercator (UTM) system, the scale factor on the central meridian of each zone is:
सही उत्तर: ग) 0.9996
UTM applies a scale factor of 0.9996 at the central meridian so that scale error is distributed across the 6° zone.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
The Mercator projection is widely used for navigation charts because it is:
सही उत्तर: ख) Conformal, so that lines of constant bearing appear as straight lines
Mercator preserves angles (conformal), so rhumb lines plot as straight lines, though areas are exaggerated near the poles.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
The reference ellipsoid traditionally used for the geodetic datum of Nepal is the:
सही उत्तर: क) Everest 1830 ellipsoid
Nepal's national geodetic datum is based on the Everest (1830) ellipsoid, inherited from the Survey of India.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Nepal's national maps use the Modified UTM (MUTM) projection, in which each zone has a width of:
सही उत्तर: घ) 3° of longitude
MUTM in Nepal uses 3° zones with central meridians at 81°, 84° and 87° E, reducing scale distortion compared with 6° UTM zones.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
The longitude of a place is:
सही उत्तर: ग) The angle measured along the equator between the prime meridian and the meridian of the place
Longitude is measured east or west of the Greenwich (prime) meridian; latitude is measured from the equator.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
A Laplace station in a triangulation network is a station at which:
सही उत्तर: ख) Astronomical azimuth and longitude are observed to control the azimuths of the network
Laplace stations provide astronomical azimuth checks that prevent the accumulation of azimuth errors in triangulation.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
In setting out a simple circular curve by Rankine's method, the total deflection angle from the back tangent to the point of tangency equals:
सही उत्तर: क) Half the deflection angle of the curve (Δ/2)
The tangential angle to any point is half the central angle, so for the end of the curve it is Δ/2.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
A vertical curve provided where an ascending gradient meets a descending gradient is called a:
सही उत्तर: घ) Summit curve
A summit (crest) curve is convex upwards; a valley (sag) curve is formed where a falling grade meets a rising grade.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
यी अभ्यास प्रश्न हुन्, आधिकारिक प्रश्न होइनन्। पाठ्यक्रम, विज्ञापन र नतिजाका लागि सम्बन्धित निकायको आधिकारिक वेबसाइट हेर्नुहोस्। उत्तरमा गल्ती भेटे प्रश्नमुनिको "टिप्पणी / गल्ती रिपोर्ट" मा लेख्नुहोस्।
नमस्ते! पाठ्यक्रम, सामान्य ज्ञान, भाषा परीक्षा वा कुनै प्रश्नको उत्तर बुझ्न सोध्नुहोस्।
AI ले गल्ती गर्न सक्छ। महत्वपूर्ण कुरा आधिकारिक स्रोतमा जाँच्नुहोस्।