इन्जिनियरिङ सेवा सब-इन्जिनियर (पाँचौँ तह) – प्राविधिक पत्र
इन्जिनियरिङ सेवा – सब-इन्जिनियर (पाँचौँ तह)
Sub-Engineer – 5th Level · Engineering Service
१,५०३ प्रश्न उपलब्ध। मोड छान्नुहोस्:
प्राविधिक पत्र: प्रश्न र उत्तर
सही लागेको विकल्पमा थिच्नुहोस्। सही भए हरियो, गलत भए रातो देखिन्छ; ५ सेकेन्डपछि सही उत्तर र व्याख्या देखिन्छ।
सही: ० / ०
-
Blockboard consists of:
सही उत्तर: ख) A core of wooden strips (blocks) glued side by side, faced with veneers on both sides
Blockboard has a core of softwood strips sandwiched between veneers, giving a stiff board suitable for doors and shelves.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Particle board (chipboard) is manufactured from:
सही उत्तर: ग) Wood chips or particles bonded with a synthetic resin under heat and pressure
Particle board uses wood chips/particles mixed with resin and pressed into sheets.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Quarter sawing (radial sawing) of logs is preferred for high-quality boards because the boards:
सही उत्तर: ग) Shrink and warp less and show the figure of medullary rays
Quarter-sawn boards have growth rings nearly perpendicular to the face, giving better dimensional stability and attractive figure.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Bethell's process of preserving timber is a:
सही उत्तर: क) Full-cell pressure process in which preservative is forced into the timber after a vacuum
In the full-cell (Bethell) process a vacuum is applied first, then preservative is forced in under pressure, filling the cells.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Wet rot in timber typically occurs when the timber is:
सही उत्तर: ख) Subjected to alternate wetting and drying
Alternate wet and dry conditions favour fungal decay (wet rot); timber permanently dry or permanently submerged decays far less.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
A ring (cup) shake in timber is a crack that:
सही उत्तर: ग) Separates the wood partly or wholly along the annual rings
Cup and ring shakes are circumferential separations between annual rings, often due to frost or uneven growth.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
The main function of mortar in masonry is to:
सही उत्तर: क) Bind the units together and distribute loads evenly
Mortar bonds bricks or stones into a single mass, fills joints and spreads loads uniformly.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Gauged mortar is:
सही उत्तर: क) Lime mortar to which cement is added to improve its strength
Gauging lime mortar with cement (cement-lime mortar) increases strength while keeping good workability.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Kankar, found in nodules in some soils, is used for producing:
सही उत्तर: क) Hydraulic lime
Kankar is an impure limestone containing clay; burning it yields hydraulic lime.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
-
Poor (lean) lime contains a high proportion of clay impurities (more than about 30%) and therefore:
सही उत्तर: ख) Slakes and sets very slowly and is used only for inferior work
Poor lime is impure; it slakes and sets slowly, has poor binding properties and is used for low-grade work.
💬 टिप्पणी / गल्ती रिपोर्ट (०)
यी अभ्यास प्रश्न हुन्, आधिकारिक प्रश्न होइनन्। पाठ्यक्रम, विज्ञापन र नतिजाका लागि सम्बन्धित निकायको आधिकारिक वेबसाइट हेर्नुहोस्। उत्तरमा गल्ती भेटे प्रश्नमुनिको "टिप्पणी / गल्ती रिपोर्ट" मा लेख्नुहोस्।
नमस्ते! पाठ्यक्रम, सामान्य ज्ञान, भाषा परीक्षा वा कुनै प्रश्नको उत्तर बुझ्न सोध्नुहोस्।
AI ले गल्ती गर्न सक्छ। महत्वपूर्ण कुरा आधिकारिक स्रोतमा जाँच्नुहोस्।